|
|
Post by adrianbv6 on Apr 9, 2005 17:49:26 GMT -5
any ideas how to get hunt ....for some people it might work when is on hunt it downloads the channel lineup
post here how
|
|
andak
New Member
Posts: 7
|
Post by andak on May 17, 2005 23:48:31 GMT -5
When I factory reset to "0" my ebay box. With "0" cannot flip channel, so I did factory reset again. Here "hunt" appear. Leave for 1 day(read on forum about this)still went back to "0". Keep doing fr2"0" several times I get "load". Still went back to "0". Will try to do frc2"0" with clone FW and nvram on my area...see what happen...I post result.
|
|
|
|
Post by patsfan on May 18, 2005 16:38:53 GMT -5
i don't think any of the 2224/2244 boxes with only the factory firmware (5.50 in all boxes i have seen) will even display "hunt". they all usually go to "0" until they are told to download a newer firmware. i know none of the the 2224 boxes in my cable system display "hunt" but all of the newer 2500 model dct's do. makes me think that if a 2224/2244 box does display "hunt" it because a newer firmware is installed.
so to sum up, alot of people probably won't be able to get "hunt" on their boxes depending on which cable company the box is from.
|
|
|
|
Post by usbbdm on May 18, 2005 16:47:04 GMT -5
If I clone a legal box's NVRAM to another box, with TV signal plugged in, the new box will show "HUNT" for about 1-2 seconds and then back to normal. No "Hunt" any more. No firmware download happened. When I have time, can check in the firmware why go there.
|
|
andak
New Member
Posts: 7
|
Post by andak on May 19, 2005 23:44:21 GMT -5
Factory reset with clone new FW from legal box. "hunt" appear for 1-2 sec then box turn off. Power-on box, get "0" again.
|
|
|
|
Post by elvanwzrd on May 21, 2005 18:50:37 GMT -5
how do you do a "factory reset" and what is the benefit?
|
|
|
|
Post by patsfan on May 22, 2005 5:16:45 GMT -5
how do you do a "factory reset" and what is the benefit? hold power and select on the front of the box and p;ug in power. keep the buttons held in for a few seconds. leds will flash as long as power is applied. there is no real benefit, all it does is reset the box to the deafult firmware before it left the factory. this will NOT erase ppv memory. |
|
|
|
Post by elvanwzrd on May 22, 2005 15:58:08 GMT -5
Will this erase any downloaded firmwares, or does it just re-enable the original firmware and disable the latest firmware.
I have a box like this... in diag screen shows both versions, latest is disabled and original is enabled. 'Wish I could get rid of the new firmware, so this box can re-download the latest firmware and enable it.... or better still, just re-enable the lates firmware LOL
|
|
|
|
Post by patsfan on May 22, 2005 17:04:24 GMT -5
yes it will erase everything other than the default firmware. after the reset your box will show "0". i haven't tried to reload firmware after a factory reset, so no gaurentee you get anything other than "0" after you do it.
|
|
